G
LINEAR · 33g
linear clacky Gateron

Gateron Magnetic Jade Delta HE

Gateron Magnetic Jade Delta HE: a Hall effect linear with a triangular stem, 33g actuation and a clacky, high-pitched sound. Our hands-on take.

33g
Actuation
1.5mm pre-travel
3.5mm
Travel
total key travel

How it feels

Feel ratings not yet recorded for this switch.

How it sounds

clacky
Profile clacky
Noise level —
Spring ping None

Full review

Quick Summary

The Gateron Magnetic Jade Delta HE is a Hall effect linear built around a redesigned triangular stem and a patterned “delta” top housing meant to cut wobble and keep travel consistent. It’s a light, fast switch with a bright, clacky character that suits gamers chasing adjustable actuation and rapid trigger, as well as typists who like a crisp, high-pitched sound. If you have an analog board and want a stable, smooth HE linear without fuss, this is an easy recommendation.

Specs and Feel

This is a linear from top to bottom, with no bump and no click, and a short 3.5mm total travel that feels quick under the finger and pairs naturally with the low actuation point you can dial in on an HE board. Actuation lands around 33g, so the keystroke stays light and effortless during long sessions. The headline change here is the stem: swapping the usual rectangular pole for a triangular cross-section measurably tightens stem wobble, and the housing feels planted rather than rattly. Factory lube is applied well, so the downstroke is smooth with no noticeable scratch through the stroke. The sound leans high-pitched and clacky, crisp and rich rather than deep or muted, which reads as snappy on most plates.

Tuning

Treat this one as stock-and-go. It arrives factory-lubed and, like most magnetic switches, isn’t meant to be cracked open or hand-lubed, so any meaningful “tuning” happens in firmware: tune your actuation depth, rapid-trigger sensitivity and dead zones in the board’s analog settings rather than touching the switch itself. A foam or tape mod on the case will warm up the otherwise bright tone if it’s too sharp for you.

Verdict

Buy it if you run an analog/HE keyboard and want a light, stable linear with a clean, clacky voice. The triangular stem genuinely helps with wobble and the stock smoothness is good. Skip it only if you’re on a standard mechanical PCB, since the Hall effect design simply won’t register there, or if you prefer a deeper, softer sound signature. For its niche, it’s a confident pick.

Frequently asked

Is the Gateron Magnetic Jade Delta HE a Hall effect switch?

Yes. It is a magnetic Hall effect linear, so it needs an analog HE-compatible board to use its adjustable actuation and rapid-trigger features. It will not register on a standard mechanical PCB.

What boards work with the Jade Delta HE?

It uses an N-pole-down magnet orientation and is compatible with most major analog platforms, including Wooting, SteelSeries, Corsair, NuPhy, MelGeek, KBDfans and similar HE keyboards. Always confirm polarity and socket support before buying.

Does it need lubing?

No. It ships factory-lubed and runs smoothly out of the box, and most HE switches are not designed to be hand-lubed or opened. Use it stock.

Compare Gateron Magnetic Jade Delta HE against another switch

Stack specs, sound profiles, and feel side by side.

Browse all switches →